MaxScale 1.4 CLI
CLI
The command line interface as used by maxadmin. This is a variant of the debugcli that is built slightly differently so that it may be accessed by the client application maxadmin. The CLI requires the use of the maxscaled protocol.
Configuration
There are two components to the definition required in order to run the command line interface to use with MaxAdmin; a service and a listener.
The default entries required are shown below.
[CLI] type=service router=cli [CLI Listener] type=listener service=CLI protocol=maxscaled address=localhost port=6603
Note that this uses the default port of 6603 and confines the connections to localhost connections only. Remove the address= entry to allow connections from any machine on your network. Changing the port from 6603 will mean that you must always pass a -P option to the maxadmin command.
Content reproduced on this site is the property of its respective owners,
and this content is not reviewed in advance by MariaDB. The views, information and opinions
expressed by this content do not necessarily represent those of MariaDB or any other party.
